Hi All, I have ordered some weatherstripping from LMC and am installing it on the truck, which didn't have any at all. The on-the-cab weatherstrip went on no problem, but the doors have a hard time shutting all the way as it is very thick. I may have to adjust the door side of the hinge and the striker post if it doesn't squish down on its own over time.
But there is also a piece of weatherstripping that goes on the door:
Labelled 2 on that image from the LMC web site. There are LH and RH versions, I think they are identical except for which end has a small plastic pin in it. The pin has "fins" on it that look like it is designed to be pushed into a hole for location purposes. In the image above, it would appear that the pin end would be at the top rear of the door. But I don't see any hole there for the pin to go in. Consequently, I'm not sure if this should go all the way against the lip at the outside of the door, or if it should be somewhat inboard.
Does anybody have a photo of this installed on their truck that I could use for guidance?
Thanks!
Pete
81 F150 Flareside, Edelbrock Pro Flow4 FI, hydraulic roller 351W, E4OD, 4x4, BW1356
92 F150 RCLB 351W E40D BW1356 mostly stock