Intermitant wiper switch and govenor assembly [used]

[1986F150Six]

Lower than usual price.

https://www.ebay.com/itm/1980-Ford-Truck-Windshield-Intermitant-Wiper-Switch-Assembly-OEM/254392449293?hash=item3b3af8b90d:g:L-wAAOSwn~JdqUBT

[salans7]

It should be known that this is the bricknose version, and not the bullnose version. I was able to mount the bricknose version to the dash on my non/a-c truck, and even that was a tight fit.

[Rembrant]

salans7 wrote

It should be known that this is the bricknose version, and not the bullnose version. I was able to mount the bricknose version to the dash on my non/a-c truck, and even that was a tight fit.

I have one I removed from a 1991 F250 but haven't installed it in my 1984 yet. My truck is a Non-AC, and there seemed to be lots of room back there, but then again I didn't try to fit it back there yet either...lol.

Gary has a page on the upgrade in the Wiper section.

[FuzzFace2]

It looks like the same one I installed in mine and I have AC.
The switch and wiring went right in.
On the box I could not find a screw or hole that would line up with the screw hole clip and "tab" to fit on the bottom of the dash frame to look factory installed but it is mounted up out of the way.
Dave ----

[salans7]

I was able to find a matching hole for the tab and screw in my 86 dash next to the wiper switch, which may be why mine was a tight fit. I was worried about it being too close to the clutch switch on the pedal assembly.