Hi,
I'm going to take the Holley 390 off my 4.9L I6 & Offenhauser C, and install a Motorcraft 2150.
Can someone please tell me what I should connect to these 2150 connections...?..
rear left corner of base plate
right rear of the air horn
right front corner of base plate under choke housing
front left corner of base plate under power valve
top center of air horn (fuel bowl vent?)
choke housing - not the 12V
My Holley has distributor advance connected to the primary metering block, 12V to choke, gas to inlet,
and air cleaner to valve cover PCV inlet.
Grateful for any help clearing up my confusion over what to connect where....
Thanks
Jim
1981 Bronco, 4.9L I6, Offenhauser C Intake, Holley 390 Carb, Hooker Headers, ZF5 Manual Trans - '95 F350, NP205 Transfer Case - '79 F150, Dana 60 4:10 Front Axle - '95 F350, Sterling 10.25 4:10 Rear Axle - '95 F350, Ruff Stuff Disc Brake Conversion, P/S, P/B
1992 F250, Ext Cab, 7.3L IDI, 4x4, Banks Sidewinder, Banks EGT Monitor
Locked
