Camber sleeve?

[BeagleRock]

 Camber sleeve or whatever its called isn't up far enough. I tried to use a blunt chisel to peck it back up but no luck.
 Do I need to remove upper ball joint and try again?  Passenger side looks just like the pics I took prior to r&r.
Not sure why it dropped down so far. The passenger side is almost flush but driver side is out or down nearly an inch and the sleeve itself isn't much longer than that.
 Help me please as I was about ready for the test drive and thought this might be dangerous.

[Gary Lewis]

I'm having a hard time envisioning how it could go down too far.  Can you post a pic?

Meanwhile, I'll look for a pic of mine....

[Gary Lewis]

Here's a pic of the one on Big Blue.  You can just see the eccentric below the nut.

[BeagleRock]

Yours is different as it goes down through the top with the nut facing upward where as mine is opposite.
 I wish I could figure out how to post a pic but able and I don't see eye to eye. I can't even post a profile pic

[BeagleRock]

Check the FB page and it will be circled in white.
 

[Rembrant]

They should stick down approximately this far in the picture below. Is that any help?

[Gary Lewis]

Randy - Here's the pic you posted.




And here's what I see in the Documentation/Suspension & Steering/Alignment page:



Does that help?

[BeagleRock]

 Yes it does Rembrant, the passenger side looks like that however the driver side is considerably lower. Kind of like it fell down while tightening the bball joint nut. I should've noticed that before I tourqed it down which spreads the sleeve.

 I believe I'm going to have to loosen the bJ nut then try and tap the sleeve back up to its rightful position.
 Thank you very much!

[BeagleRock]

Got it done,thank you!

[Gary Lewis]