1984 bronco NP 208F output seals

[Leatherneck_1775]

CONTENTS DELETED

The author has deleted this message.

[ArdWrknTrk]

You might have better luck posting in the main forum.

Are you looking for the output seals. E0TZ-7B215-B, or the rubber seal washer that goes in under the yoke nut?

[Leatherneck_1775]

The Eotz ones Ard
. I have found them just now on Ebay

[ArdWrknTrk]

So, that's a National 3946, SKF 18992 ?

Or the double lip SKF 18771 ?

[Leatherneck_1775]

Going off the part number from this site they showed up on E Bay and where in Ford boxes. I am going to check the one NAPA sold me for the NP 208 asfar as dimensions but the seals don't look the same.

[Leatherneck_1775]

The NAPA one is an SKF 18992 Jim. I checked this SKF 18992 and the O.D is smaller then the output I.D dimensions

[ArdWrknTrk]

Single lip then....

You might want to check dimensions on the double lip seal.

There must have been a reason for it.

[Leatherneck_1775]

I will Jim. Much appreciated.

[ArdWrknTrk]

The 18771 is 1 7/8 ID 2 3/4 OD and a half inch deep